By far the biggest challenge in dust collection is keeping the dust from clogging the filter bags. We have all experienced how great a dust collector works when it is new and the filters do not have any dust inside. Soon the filter has a cake of fine dust inside and the air flow is reduced to almost nothing. The main purpose of a cyclone type dust collector is to minimize the “clogging of filters as much as possible. Inside of the cyclone the air and dust particles are forced against the inside of the cyclone wall. Since dust particles are heavier than clean air these particles fall down into the drums, and 99.9% clean air is evacuated through the center of the cyclone. The second advantage of the Cyclone design is that the suction impeller is positioned after the cyclone. This allows us to use a fan design with higher performance. The fan design we use is both more efficient and more quiet.
10HP Cyclone Dust Collector Specs
MDC1300-045
Motor power: 10 Hp 220 volts 3 phase 60 Hz
Impellar size: 16" double walled welded steel
CFM: 5000 CFM
Maximum static pressure: 22"
Inlet size: 13" or 5 ports 4" each
Filter Bag dimentions: 100" X 24" times 2
Filtration: 1 Micron filter bags
Total height w/ inflated bags: 13' 4"
Floor space required: 114" X 62"
Dust capacity in drums: 60 gallons x 2
Net weight: 540 lbs
Gross weight: 750 lbs
Noice Level: 88 DB Magnetic on off switch with radio frequency remote control included.
